Rustins Quick Dry All Surface All Purpose Paint – ASAP Paint – 250ml

Description

Rustins Quick Dry All Surface All Purpose Paint, known as ASAP Paint is a high performance acrylic satin paint available in White, Red, Green, Cream, Blue, Grey and Black. It is used on a wide range of surfaces such as UPVC, most plastics, timber, metal, tiles, stone and bricks without the need of a primer. It is quick drying and easy to apply to on an extensive range of surfaces both indoors and outdoors.

How to use Rustins Quick Dry All Surface All Purpose Paint

1. The surface must be clean and free from dust and any loose paint, wax, grease, dirt, fungal growth or solid matter likely to interfere with the adhesion of the paint.
2. Do not apply to damp areas. Sources of damp should be eliminated before applying the paint.
3. The product can be applied to surfaces without the need of a primer. However on metal improved protection will be achieved if an anti-corrosive metal primer such as Rustins Quick Dry Red Oxide Primer or Rustins Galvanised Primer is first applied.
4. The product can also be applied directly to timber but a suitable primer such as Rustins Quick Dry Primer and Undercoat will help to reduce the appearance of the grain of the timber if this is important.
5. STIR WELL BEFORE AND DURING USE. Do not thin the product.
6. Apply evenly by brush.
7. One or two coats should be applied allowing 3-4 hours between coats in warm dry conditions.
8. Cold damp conditions will significantly extend the drying times.
9. Do not apply outdoors when foggy or likely to rain before the paint has dried.
10. 1 coat is usually sufficient. A second coat may be applied for improved durability.

---

Please note

Drying Time is Approximately 30 minutes, depending on temperature and humidity.

Do not apply if rain imminent.

For maintenance, the surface may be washed with a mild detergent solution and a scrubbing brush and re- coated if necessary.

Compatibility May be applied to a wide range of surfaces and paints but test for compatibility and adhesion if in doubt.

Store in cool dry area

Remove excess product from brushes before cleaning. Clean brushes whilst wet with water.   Hard brushes can be cleaned with Rustins Brush Restorer.

Application Temp. Ideally 15-25ºC.

Approx Coverage 12-14 sq.metres per litre 1 coat

Always wear protective gloves when using this product.

Always test in a small inconspicuous area first to ensure you are happy with the results.

---

Health and Safety

Keep out of reach of children. Avoid contact with skin and eyes.  After contact with skin, wash immediately with plenty of soap and water or a proprietary skin cleanser. In case of eye contact copiously wash eyes immediately with water and seek medical advice.