Rustins Danish Oil

A clean, lint-free cloth is an excellent way to apply Rustins Danish Oil. Make sure the wood is clean, bare and free from any previous finish. Apply the oil liberally with the cloth and allow approximately five minutes for it to penetrate the timber. Use a separate clean lint-free cloth to wipe away any surplus oil. Repeat for each additional coat, allowing the previous coat to dry first. A clean brush can also be used.

Rustins Danish Oil is a clear, natural-coloured oil that produces a soft, low-lustre satin finish rather than a high gloss. Like most wood oils, it can slightly deepen or warm the natural colour of the timber. The appearance may become a little richer as additional coats are applied. We recommend testing on an inconspicuous area first to see how the oil will affect your particular wood.

There are several possible reasons. The wood may not be completely bare, clean and dry, or it may have residue from a previous finish that is preventing the oil from penetrating. Naturally oily woods such as Teak and Iroko can also affect drying. Another common cause is leaving too much surplus oil on the surface. Always wipe away excess oil after application and ensure the timber has been properly prepared before applying further coats.

This depends on the type of wood, the amount of wear and whether the surface is indoors or outdoors. Interior surfaces may only need occasional maintenance when the finish starts to look dry or dull. Exterior timber is exposed to weather and will generally require more frequent re-oiling. Check the condition of the surface regularly and apply further oil when needed, following the preparation instructions.

No. Rustins Danish Oil is a clear, natural-coloured wood oil and is not available in different tinted shades. If you are looking for a coloured Danish Oil, we also stock Colron Danish Oil which is available in a range of tinted colours. Please check the available shades on the product page.

Yes. Rustins Danish Oil is suitable for wooden kitchen worktops. The product conforms to the Articles in Contact with Food Regulations stated by Rustins. Ensure the wood is properly prepared and follow the application instructions, allowing the finish to dry fully before the surface is put back into use. Always follow the manufacturer’s guidance for food-contact surfaces.

One litre of Rustins Danish Oil covers approximately 14m² per coat. This will depend on the type and absorbency of the wood. More porous softwoods, such as Pine, may absorb more oil than denser hardwoods, so actual coverage can vary. Remember that three coats are recommended on bare wood.

Rustins recommends applying three coats to bare wood. Allow approximately 4–6 hours between coats, depending on the temperature and humidity. More porous timber may absorb additional oil, so always ensure the surface is properly treated and wipe away surplus oil after each application.

Yes. Rustins Danish Oil can be used outdoors as a primer-sealer beneath a suitable exterior coating. It can also be used on its own as a higher-maintenance finish, but it will require additional coats and regular re-oiling to maintain its appearance and protection.

No. Rustins Danish Oil is intended for bare, untreated timber. Existing varnish, paint, wax and other surface coatings should be removed before application so that the oil can penetrate the wood.

It can be used on suitable veneered surfaces, but take care when preparing the timber. Avoid sanding through the thin veneer layer. For veneered doors and timber, check the furniture manufacturer’s instructions first, as some factory-applied coatings may not be suitable for this type of treatment.

Clean brushes with white spirit while the oil is still wet.