Description
Polyvine Decorators Varnish can be used on emulsion paint, wallpaper and other surfaces to offer long-term protection against finger marks, stains, scuffing and colour fading. This can be used on interior or exterior projects and offers a quick drying, water resistant, stain resistant, abrasion resistant, micro-porous and UV filter finish. This unique, clear acrylic varnish uses nanotechnology to protect a wide range of decorative surfaces such as paintwork, wallpaper, fabric, wood and plaster-work. It also offers UV protection which helps to reduce ageing and deterioration.
How to use Polyvine Decorators Varnish
- Ensure the surface to be coated is clean and free from grease, wax or polish
- Stir well before use.
- Gloss or Satin: Apply 2-3 coats.
- Dead flat: Apply 1-2 coats.
- Dilute 10% with water to prime porous surfaces.
- Use a good quality synthetic brush or by conventional spray or High-Volume Low-pressure spray.
- If cissing occurs, rub onto affected area with a damp cloth to break the surface tension and re-apply.
- Where a dead flat finish with a high degree of protection is required. Apply satin and finish with a thin coat of dead flat.
Please note
Always apply to a test area before starting work. Appearance may vary according to the colour and type of wood and the number of coats.
Do not apply over uncured oil paints.
Apply dead flat finish sparingly and brush out well, over application could result in misting.
Test dead flat finish for misting over dark colours.
Test dead flat finish on all wallpapers to ensure compatibility.
When applied over emulsion/latex paint, it is possible that Decorators Varnish can draw certain stains through the paint, which would not otherwise be visible.
Do not apply over uncured oils.
COVERAGE – Approx. 15-20 sq. m per litre.
CLEAN UP – Any equipment used can be cleaned using soap and water before the clear coat dries. Wipe any excess off surfaces with a damp cloth. Any dried deposits will need a paint stripper to remove them.
Drying time – 1 to 2 Hours @ 20°C / 70°F Low temperature/high humidity increases drying time.
Cure Time – Up to 5 days @ 20°C / 70°F
Re-coat Time – Up to 2 Hours @ 20°C / 70°F
STORAGE – Store in unopened containers in a cool dry place away from direct sunlight.
Health and safety
Non-hazardous. Ensure good ventilation. Keep out of reach of children. Contact with eyes-wash immediately with warm water. Remove excess from tools and mixing vessels before washing in warm soapy water. Do not empty containers into drains or watercourses.
Safety Data Sheets
Reviews
There are no reviews yet